EPDM sealing tape, full-surface self-adhesive for outdoor use
SEALTPE-RAL-OUTS-EPDM-FSA-0,6X200MMX20M
Art.-no. 0875350206
EAN 4058794310375
Register now and access more than 125,000 products
Full-surface, very strong self-adhesive
- Simple, time-saving application.
- Very secure adhesion on many typical construction surfaces.
- No curing time.
- Easy application thanks to the two-part backing paper on widths of 150 mm and above.
Watertight and breathable
- Provides a reliable seal against water from outdoors.
- Water vapour permeable membrane allows water vapour to permeate from inside to outside, thereby preventing moisture-related structural damage.
- Excellent resistance to weathering for a permanent, reliable seal.
Extremely high elasticity
- Optimum safety in case of component movements.
- Convenient to apply due to highly flexible tape.
- We recommend EPDM sealing tape adhesive to level out uneven surfaces, for applying to the film edge to prevent backwater penetration behind it, in corners or at butt joints.
- Secure the tape to the element using an additional mechanical fixing such as a window ledge. Clamp it within the element, in the clamping batten, socket rail etc.
- Not suitable for sealing against pressurised water.
- Tape cannot be plastered over.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Permanent, reliable sealing of joints outdoors, e.g. for window sills, conservatories and façades as well as in timber construction and pre-fabricated building construction. Sealing of blind joints.
Preparation
- Substrates must be load-bearing, dry and free of ice, dust and grease.
- Absorbent and porous surfaces must be pre-treated with butyl/bitumen primer or spray primer.
Installation
- Pull off the protective film.
- Cut to length.
- Apply tape without creasing or folding.
- To ensure proper adhesion, the tape must be pressed onto the surface and smoothed with a press-on roller or a similar tool.
Colour | Black |
Backing material | EPDM |
Adhesive base | Acrylate |
Width | 200 mm |
Thickness | 0.6 mm |
Length of roll | 20 m |
Min./max. processing temperature | 5 to 30 °C |
Min./max. temperature resistance | -30 to 75 °C |
Building material class/conditions | E - Normally inflammable / in accordance with DIN EN 13501 |
Ultraviolet resistance | Yes |
Elongation at break | 250 % |
Resistance against | Bitumen |