Contact Clean adhesion promoter
Adhesion promoter clear primer
PRIM-WNDWADH-CONTACTCLEAN-20ML
Register now and access more than 125,000 products
- Transparent adhesion promoter for Revolution window adhesive
- Activator for trimming (remaining bead) and PU/PVC pre-coated windows
Product provides no UV protection. Please do not wipe off. Shake the container well before opening.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
All windscreens/windows in the car replacement glazing sector for passenger cars and small vans. Pre-treatment of window when replacement glazing is used (ceramic-coated).
Surfaces must be fully dry, clean and grease-free. To do so, clean the bonding surfaces with an active cleaner. Shake Contact Clean adhesion promoter before use. The Contact Clean can then be applied. Guide pad, art. no. 0890024515: The pad is activated by briefly bending the handle (slight click). The content is applied using the textile side (red) over the perforated ceramic area. One application is sufficient. The window adhesive can be applied once it has fully flashed off (15 minutes). For more information, please refer to the technical data sheet.
Container | Can |
Contents | 20 ml |
Chemical basis | Naphtha |
Colour | Transparent |
Min. flash-off time | 15 min |
Flash-off time conditions | at 23°C and 50% relative humidity |
Min. processing temperature | 5 °C |
Max. processing temperature | 25 °C |
Last viewed
1/2 inch impact socket wrench insert DIN 3121/ISO 1174
1/4 inch bit holder, magnetic
Hexagonal bolt with shank and fine thread DIN 960, steel 10.9, plain
Slotted cheese head DIN 84, steel 4.8, zinc-plated, blue passivated (A2K)
C 6.3 slotted bit (1/4 inch)
Countersunk head screw with hexagon socket ISO 10642, A2-070 stainless steel, plain
Raised contersunk head tapping screw, C shape with H recessed head DIN 7983, steel, zinc-plated black (A2S), with H cross recess.
Cordless hand-held circular saw AHKS 18-68 COMPACT M-CUBE
CUT+COOL Perfect drilling and cutting oil
Polishing pads